Juma PA-100D v3.0c Build 6

Software developed by Adrian

Juma PA-100D v3.0c Build 6

Postby 5B4AIY » 08 May 2018 06:22

This version is a maintenance build. It does not introduce any new features, but simply cleans up some code, and fixes some minor inconsistencies. For full details, read the comments in the file juma-pa100.c at line 481 onwards which covers version 3.00c.

This version can be safely loaded over the previous version 3. If loading over an earlier version, be aware that as the EEPROM mapping has changed as new features were added, that this will cause a 'Checksum Error!' message on first switch-on after loading. This is perfectly normal, and only occurs the first time. Please make a note of your existing calibration and configuration settings prior to loading this version.

If you are updating from an original firmware (Versions earlier than 2.0) then as the measurement system is completely different you will have to re-calibrate the amplifier.

73, Adrian, 5B4AIY
PA-100D v3.00c Build 6 (C-Source+HEX Load File+user Manual).zip
Updated firmware.
(259.49 KiB) Downloaded 298 times
Posts: 188
Joined: 13 Nov 2011 09:22
Location: Cyprus

Return to Juma Firmware by 5B4AIY

Who is online

Users browsing this forum: No registered users and 1 guest