Juma PA-100D v3.0c Build 7
Posted: 27 Apr 2020 10:07
This update fixes a very minor and subtle bug, as well as optimizing the fan speed control code. The bug was that in the Calibration & Setup the number of words saved and the CRC was not sent when a serial terminal was connected. As for optimizing the Fan Speed code, as a result of the enforced lock-down measures, I had nothing else better to do!
This version can be loaded over a previous version 3, but if you update from any earlier version you will have to at least re-check the calibration values, and if you update from an original version since both the measurement systems and the EEPROM mapping changed, you will have to re-calibrate. Fortunately most of the settings are determined in hardware, so only some software values will need resetting.
As before, it is a good practice to make a note of your existing calibration and user configuration settings prior to updating. There are pages at the back of the User Manual specifically for this data.
Adrian, 5B4AIY
This version can be loaded over a previous version 3, but if you update from any earlier version you will have to at least re-check the calibration values, and if you update from an original version since both the measurement systems and the EEPROM mapping changed, you will have to re-calibrate. Fortunately most of the settings are determined in hardware, so only some software values will need resetting.
As before, it is a good practice to make a note of your existing calibration and user configuration settings prior to updating. There are pages at the back of the User Manual specifically for this data.
Adrian, 5B4AIY